Your shipping charge has been added to this package price. The standard two week lead time still applies. If you would like expedited services, please let us know and we will adjust your quote.
Measurements on this quote:
Qty: 1 @ 59.5"x29.5"
Pre-wiring of sheet = all pre-wiring logistics and any other special requests will be discussed after full payment has been made.
Total square footage: 12.5
Smart Tint provides a simple and cost effective alternative to other Switchable Film technologies. It is manufactured with a self-adhesive cling layer on one side (peel and stick) which makes it easy to apply to both new and existing glass (no special installation equipment required).
A simple ON - OFF mode switches the film from being tinted grey to black. In its frosted grey state the film acts as an electronic blind providing privacy and security for any glass, window or partition.
Smart tint is available in 47 1/4" " x 120" and can be trimmed to size. Custom shapes and sizes are available pre-wired and ready to install. .
Smart Tint Film Specification
"Power - 110VAC
"Frequency - 50/60Hz
"Current - 0.1 amperes per m2
"Power - 7 watts per m2
"Switching - less than 1 second in optimal conditions
"Operation - (on) light tinted grey (off) glossy black
"Thickness - 1.5 mm
"Light transmittance - On (85%) Off (8%)
"Haze Coefficient - On (5%) Off (93%)
Smart Tint Film Test Procedures
"Tested over 3 million switches
"High temperatures - >70 degrees C
"High temperature / humidity - >50 degrees C / 95% RH
"Cold temperatures - minus 20 degrees C (over 14 days)
"UV filtering - 99%
Smart Tint Features
"Self adhesive Smart Cling Technology film (peel and stick)
"Custom cut sizes and shapes" Circles , half moons, stars etc.
"Sheet sizes up to 244"
"Film widths 47.25"
"Simply apply to flat glass, plexiglass or hang like a curtain"
"Suitable for permanent or temporary applications
"UV / solar protection"
Smart Tint is Dimmable - You can manually adjust the level of tint with the appropriate controller.
The 344-2 NR power control unit is extremely efficient and designed for long term permanent installation.
The 344-2 NR is made of fine copper material, and has a very stable output. This 100W unit controls up to 150 sq. feet or 15 square meters of smart tint material and is constructed of a high performance flame retardant epoxy resin casting that is water resistant . The operating temperature is very low and suitable for various environments.
The 344-2 NR power control unit has a circuit board that utilizes a self recovery system designed to cut the power by itself when over loaded. This system will auto restart when over load or short is corrected.
•Rated Power: 100W
•Rated Ampere: 2A
•Input Voltage: AC110 vac or 220 vac ( just let us know in the comment section at check out which unit you require)
•Output voltage: AC75V
Size: 155*90*72 mm