How to cut and trim in the field

Cut and trim the material at your own risk. This technology is delicate and we always recommend you provide us the correct measurements so we can professionally cut to size at our facility eliminating any risk of material fault.

Measure 3x and we will cut once.

DO NOT use a razor knife

Ideally provide us the correct measurement's and we will send a laser cut perfect ready to install piece. However if you have to trim a pair of stainless steel or titanium scissors will do the trick. Do not use a razor blade or knife it could cause delamination or leave a burr on the opposite side of the material causing it not to sit flush on the glass.

PLEASE NOTE: IF YOU DECIDE TO CUT AND TRIM YOUR SELF TO APPLY AN ACID FREE ADHESIVE ON THE CUT EDGES TO ELIMINATE ANY POSSIBILITY OF SPLITTING OR DELAMINATION. ALL WARRANTIES ARE VOID IF MATERIAL IS CUT OR TRIMMED BY ANYONE OTHER THAN AN AUTHORIZED PROVIDER/INSTALLER OR FACTORY DIRECT.